Robotics Sportster Flash x2 Podręcznik Użytkownika Pobierz pdf (Strona 23)

Sportster Flash x2 - User’s Guide 19

Controlling Link Speeds with &N

and &U

You can use the &N and &U commands to control link speeds.

Sportster modems without x2 can still use the &N and &U commands,

but can only control link speeds up to 33.6kbps.

Controlling Link Speeds

You can use the &N and &U commands to control the link speeds of

your Sportster with x2. Use the following table to determine how to use

&N and &U commands:

To limit the Use

Highest possible connect speed &N

Lowest possible connect speed &U

Range of possible connect speeds &N and &U

Note: The default values for &N and &U are 0. If you change these

values, you will limit the speeds at which you can connect. 3Com

recommends that you do not alter these values.

Limiting the Highest Possible Connect Speed

The &N command allows you to limit the highest possible connect

speed. If a remote modem attempts to connect to your Sportster with x2

at a speed higher than &N, your Courier with x2 will not allow it to

connect.

To limit the Use this command Where x is

Highest possible

connect speed

AT&N=x A value from 0 to 31

Note: See table 12.4 for a list of connect speed values.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 70 71

Brak uwag

Robotics Sportster Flash x2 Podręcznik Użytkownika Strona 23